Step1: Connecting radio to flight controller Connect one of the radios (LR900-F, LR24-F…) to the uart port on your flight controller, usually TELEM1/Serial1, but other idle ports can also be used. Note that the rx of the radio needs to be connected to the controller’s tx, and tx should connect to rx. Step2: […]
Setup Tutorial Of Telemetry Radio On Ardupilot Read More »
Step1: Connecting radio to flight controller Connect one of the radios (LR900-F, LR24-F…) to the uart port on your flight controller, usually TELEM1, but other idle ports can also be used. Note that the rx of the radio needs to be connected to the controller’s tx, and tx should connect to rx. Step2:
Setup Tutorial Of Telemetry Radio On PX4 Read More »
When using the MicoAir MTF-01 optical flow sensor, you may need to configure this sensor first on the MicoAssistant software and a USB-TTL module should used for it. In case you can’t find a TTL module around you, there is still another way that might do the job. Ardupilot has a function call
Configure MTF-01 Sensor By Using Ardupilot’s Serial Passthrough Function Read More »
CP2102 is a USB to UART IC from Silicon Labs and is used in our many products, such as LR900-F, LR24-F and etc. When using CP2102 on a PC for the first time, the driver needed to be installed. Download the Driver Driver for CP2102 (WIN7/10/11) Install the Driver Step By Step Step1
Installation Guide for CP2102 Driver Step By Step Read More »
